Setting the replication system version

After you upgrade and install Replication Servers and user databases in your replication system to a new version level, you can set the system version to match the earliest software version.

The system version is the lowest version of Replication Server allowed in the system. For example, if your replication system version is 1151, you cannot use or install a Replication Server that is earlier than version 11.5.1.

When all Replication Servers in the replication system are at version 12.6 or later, follow these steps to set the system version to 1260:

Log in to the ID Server.
Execute this command:
```
sysadmin system_version, 1102
```

Restrictions

Note these restrictions for the system version:

If the system version is less than 1102, new features that were introduced in later versions, including features of version 12.6, are not available. For this reason, Sybase recommends that you set the system version to 1102 or higher.
Even if all your Replication Servers are at version 12.6, you do not have to set the system version higher than 1102. If you do, you forego the possibility of downgrading and installing another Replication Server that is earlier than version 12.6.
When you upgrade all Replication Servers to at least version 11.0.2, you can set the system version to at least 1102.
Once the system version is set to 1102, the availability of new features is determined by the site version setting. Thus it is not necessary to set the system version higher than 1102.

System version and software version

Table 3-1 illustrates the relationship between the software version number and the system version number. Note especially the ability to use the full capabilities of version 12.6 when the system version is at 1102.

**Table 3-1: Relationship between software version and system version**
Replication Server software version	System version 1102 and higher
12.6	Full capability when site version is set to 1260.
12.5	Full capability when site version is set to 1250.
12.1	Full capability when site version is set to 1210.
12.0	Full capability when site version is set to 1200.
11.5	Full capability when site version is set to 1150.
11.0.2/11.0.3	Full capability.

New features of version 12.6 are available only when the system version is at least 1102 and the site version is set to 1260.

If a software version is supported with full capability at a given system version, you can install new Replication Servers of that software version. See “Setting the Replication Server site version” for more information.

For more information about new features, see What’s New in Replication Server? for version 12.6 and the release bulletin for Replication Server version 12.6.

If you are upgrading from version 11.0.x to 12.6, see What’s New in Replication Server? and the release bulletins for Replication Server versions 11.5 through 12.1 for information on the features that became available after 11.0.x.

Upgrading from version 11.0.2 or 11.0.3

As Table 3-1 shows, if you are upgrading from Replication Server version 11.0.2 or 11.0.3, and the system version is already set to 1102 or 1103, you do not need to set the system version to begin using new features in 12.6.

You must set the site version for Replication Servers that require it, and to upgrade routes. Information needed for the new features cannot be propagated to other sites until the corresponding routes are upgraded. See “Setting the Replication Server site version” and “Upgrading routes” for details.