If you are experiencing problems using the alter route command:
Quiesce the replicated data system prior to executing the alter route command. For more information, see the Replication Server Administration Guide.
If you are changing a direct route to an indirect route, or if you are changing the intermediate site in an indirect route, you must create a route from the new intermediate site to the destination site.
To determine the success of an alter route command, execute rs_helproute at the destination Replication Server after you alter the route. Maker sure that the output reflects the route change. If the route change did not succeed, follow the troubleshooting procedures in “Output from rs_helproute at the source Replication Server”.
