Use these commands to coordinate recovery after a database is reloaded or when Replication Server stable queues fail.
WARNING! Many of these commands should be used with caution and only in very restricted circumstances. Make sure to check the associated documentation carefully before you use them.
suspend log transfer – disconnects a RepAgent or LTM from a Replication Server and prevents either from connecting.
resume log transfer – allows a RepAgent thread or LTM to connect to the Replication Server.
resume queue – restarts a stable queue stopped after receiving a messager larger than 16K bytes. Applicable only when the Replication Server version is 12.5 or later and the site version is 12.1 or earlier.
allow connections – places Replication Server in recovery mode for specified databases.
ignore loss – allows Replication Server to accept messages after a loss is detected.
rebuild queues – rebuilds Replication Server stable queues.
set log recovery – places Replication Server in log recovery mode for a database.
For detailed recovery procedures, see Chapter 16, “Replication System Recovery,” in the Replication Server Administration Guide.
