The HL7 tab for inbound and outbound maps is the same. In the top section of this tab, specify whether to generate only an MSH message, or whether to also generate the FHS and BHS messages. In the bottom section of the tab, specify whether you expect to receive an original acknowledgement or an enhanced acknowledgement, as well as the time period during which the acknowledgement should be received.
Envelope Generation Option – select:
0072 – FHS, BHS, or
0073 – MSH Only.
Original Acknowledgement – indicates whether there is an agreement between the sender and receiver that the receiver of this EDI message will send a response back to the sender, acknowledging receipt of the message. If so, the system should expect to receive this acknowledgement.
Enhanced Acknowledgement – indicates whether there is an agreement between the sender and receiver that the receiver of this EDI message will send an enhanced response back to the sender, acknowledging receipt of the message. If so, the system should expect to receive this acknowledgement.
Consider Unacknowledged if Not Received After – enter values that tell the program the period of time in which you expect to receive a CONTRL message. If the CONTRL message is received after this time period, it is considered overdue. If you use EC Gateway, this allows EC Gateway to report on overdue acknowledgements.
Time Units specifies the unit of measure (DAYS, HOURS, MINUTES, or SECONDS) for the time period during which an acknowledgement to your outgoing message must be received.
Select the actual number of units of time (1 – 99) after which an acknowledgement is considered overdue.
