The Overrides tab of the Trade Agreements window for outbound EDIFACT maps contains mailbox override information and override information for the receiver on outbound envelopes:
In the Mailbox Override Values section:
Name – used only for reports and display. An entry in this field overrides the value you entered on the General tab of the Trading Partner window.
Folder – where the runtime engine (RTP) drops off EDI data produced by outbound maps and compliance runs and places inbound EDI data being passed through. It is used for both inbound and outbound routing. An entry in this field overrides the value you entered on the General tab of the Trading Partner window.
File Name – specify the name of an EDIFACT output file for routed data. This file name is used in the IN, OUT, GOOD, BAD, and OTHER mailboxes.
Map and Route Inbound EDI to Trade Agreement Mailbox – allows both the pass-through (routing) of data and the running of maps if selected. You must select this option to generate bad EDI and place it in the trading partner’s BAD folder. This is always used when running compliance maps.
In the Outbound Receiver Override Envelope Values section:
Any information you enter in the Interchange Qualifier and Code fields overrides the values entered in the Interchange Qualifier and Code fields in the Outbound Receiver Default Envelope Values and Inbound Sender Lookup Values section of the General tab of the Trading Partner window. For outbound EDIFACT messages, these are the Interchange Receiver Identification and Identification Code Qualifier on the UNB segment.
Any information you enter in the Group Qualifier and Code fields overrides the values entered in the Group Qualifier and Code fields in the Outbound Receiver Default Envelope Values and Inbound Sender Lookup Values section of the General tab of the Trading Partner window. For outbound EDIFACT messages, these are the Application Recipient Identification and Identification Code Qualifier on the UNG segment.
