The performance of Sybase Replication Agent can be tuned or optimized by adjusting some of the Replication Agent configuration parameters. The following section describes recommended values for various Replication Agent configuration parameters.
To set or change a Replication Agent configuration parameter, use the ra_config command.
Because Replication Agent overwrites its entire configuration file whenever ra_config or ra_set_login is invoked, Sybase recommends that you do not hand edit the configuration file. Furthermore, Replication Agent reads the configuration file only once at start up. You must use the ra_config command if you want the new configuration parameter to take effect immediately.
See Chapter 4, “Sybase Replication Agent Command Reference” for more information on using the ra_config command.
See Chapter 5, “Sybase Replication Agent Configuration Parameters” for more information about configuration parameters.
